<HTML><HTML>Greetings,            I put Michael S= avage or Glenn Beck on the radio, and pour a Sasparilla.  Then, I take = about a 12" x 12" or so,  rag which is made out of an old t-shirt or be= d sheet, wet it, wring it out, double it in half and place over the key top.= Then apply a hot iron for about 10 to 20 seconds (it'll steam).  Then,= I take a putty knife and lift under the plastic until I can push it along u= nder the plastic, going from the back of the key to the front. It should jus= t glide off. I re-wet the rag every 10 keys or so, as it dries out as you go= . If the plastic won't come off, sometimes you need to keep the iron on alit= tle longer to soften the plastic because some keytops are thicker.  <BR= >             An iron t= hat you don't use for clothes anymore is best. I have a "dedicated" iron for= this and craft purposes. After the keys cool, I take a piece of sandpaper, = tape it to the workbench or any flat surface will do, and lightly sand any r= emaining glue off the key. Julia Gottchall, Reading, PA Rodger's way sounds similar too.... In a message dated 8/12/2004 10:20:46 AM Eastern Daylight Time, roger.j@sask= tel.net writes: <BLOCKQUOTE TYPE=CITE style="BORDER-LEFT: #0000ff 2px solid; MARGIN-LEFT= : 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px">Hi Dave,             &nbs= p;    Two thicknesses of brown paper, and a clothes iron, wil= l get the plastic nice and hot, and will not discolor the wood.  &= nbsp; It should just peel off with good knife. Regards Roger </BLOCKQUOTE> </HTML>