<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML><HEAD>
<META http-equiv=Content-Type content="text/html; =
charset=iso-8859-1">
<META content="MSHTML 6.00.2800.1476" name=GENERATOR>
<STYLE></STYLE>
</HEAD>
<BODY bgColor=#ffffff>
<DIV><FONT face=Arial size=2>Terry asked: "<FONT face="Times New =
Roman"
size=3>It would seem to me that 3.5 in-lbs would be way less than that =
needed
for a<BR>flange screw. Yes? No?"<BR><BR>Terry,</FONT></FONT></DIV>
<DIV><FONT face=Arial size=2><FONT face="Times New Roman" =
size=3>When doing
flange screws, w/my cordless, I usually have it set at 4-5 on the dial, =
that has
1-6. If I am driving screws in hardwood, it usually doesn't have enough =
poop, so
I grab my Makita Drill Driver, (cordless), which will twist off 1/4x20 =
bolts if
you set it too high!<G> As always, the right tool for the right
job!<G></FONT></FONT></DIV>
<DIV>The nice things about the Panasonic, is that the lowest settings, =
(on
torque), will be very kind to an action rail that has marginal =
solidarity,
IYKWIM. Also, it can be used "straight" or in the "bent" position, so =
it's
ergonomically healthy for your Tuning Arm!</DIV>
<DIV>Best Regards, </DIV>
<DIV><FONT face=Arial size=2>Joe Garrett, R.P.T.<BR>Captain, Tool
Police<BR>Squares R I</FONT></DIV></BODY></HTML>