<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; = charset=iso-8859-1"> <META content="MSHTML 6.00.2800.1515" name=GENERATOR> <STYLE></STYLE> </HEAD> <BODY bgColor=#ffffff> <DIV><FONT face=Arial size=2>Dean May said: "<FONT face="Times New = Roman" size=3>Just wrapping up working on a YC action that has been in my = shop about 4<BR>weeks. After assembling it I notice a distinct click when the jacks<BR>reset. It appears some errant chemical vapor from the shop has hardened<BR>the jack stop felt causing a slight noise on the reset.<BR> <BR>I'm thinking perhaps a couple drops of water/alcohol/surfactant solution<BR>might do the trick to soften the = little round piece of felt.  Anybody<BR>have any input?<FONT face=Arial size=2>"</FONT></FONT></FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Dean,</FONT></DIV> <DIV><FONT face=Arial size=2>Just finished surveying/tuning/fiddling = with a YC with the same darned problem. Made in 1999 and it sounds like a tap = dancer!!! Yikes! It is the Jack Regulation Stop Felt. It is way too hard. I = perused it and all are the kind of felt that some use for understinging felt or key end = felt. Waaaayyy to darned hard. The only solution I can think of is to replace = with a much softer punching. Anyone else, have thoughts? BTW, this is a = Pramberger Series, that should be better, IMO. I wasn't impressed.</FONT></DIV> <DIV><FONT face=Arial size=2>Regards,</DIV> <DIV><BR></DIV></FONT> <DIV><FONT face=Arial size=2>Joe Garrett, R.P.T.<BR>Captain, Tool Police<BR>Squares R I</FONT></DIV></BODY></HTML>