<!doctype html public "-//w3c//dtd html 4.0 transitional//en"> <html> <body bgcolor="#FFFFFF">   Dave Nereson wrote: <blockquote TYPE=CITE> <blockquote dir=ltr style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px"> Sorry.  I meant the June issue, which I just received.  Richard's article about Touch-Weight and Lever Ratios has a diagram showing the lever arm lengths measured from key top to balance pin hole (on the bottom of the key) and from there up to the capstan.    --David Nereson, RPT</blockquote> </blockquote> The diagrams are not my doing. The editor insisted on a few things, and I dont really want to get into that. But the origional article with my own diagrams are at the following URL. <A HREF="http://home.broadpark.no/~rbrekne/touchweight.html">http://home.broadpark.no/~rbrekne/touchweight.html</A> I wasnt happy with all the changes that were insisted upon, but didnt think them severe enough to not publish. Tho, for the record, no suggestion of a  << correct >> method to measure any arm of any of the levers is intended by me. Quite the opposite really. Cheers RicB -- Richard Brekne RPT, N.P.T.F. UiB, Bergen, Norway <A HREF="mailto:rbrekne@broadpark.no">mailto:rbrekne@broadpark.no</A> <A HREF="http://home.broadpark.no/~rbrekne/ricmain.html">http://home.broadpark.no/~rbrekne/ricmain.html</A> <A HREF="http://www.hf.uib.no/grieg/personer/cv_RB.html">http://www.hf.uib.no/grieg/personer/cv_RB.html</A>   </body> </html>