<HTML><BODY BGCOLOR="#ffffff">Hi All, Just did my first "expanding bracket" replacement today on a Weber WG 60= , circa 1995 (action spread 113.5mm).  It  was for the most part p= retty straightforward.  Before I started doing the job, I noticed that = there was clicking as the hammers rebounded off the rail.  I thought it= would be solved when the brackets were replaced. The only problem was that when I got the action spread measured and set,= then set the blow distance, the clicking was still there.  Turns out t= hey were tapping the wippen assist springs as the hammers bottomed out. &nbs= p; Everything lined up and regulated okay but for this.  Has anybody h= ere had this problem on these pianos before and come up with a decent soluti= on?  I experimented with the action spread a little bit, but things jus= t did not line up the way they're supposed to.   The hammer tails are pretty thick.  I experimented with shaving off= some of the undersides so that they would miss the springs altogether, and = it seemed to do the trick.   Any ideas on this?  I'm sending my claim form off to Meadowlands Pi= ano Service today, so now it's my baby... Thanks, as always, Dave Stahl</HTML>