Should have noted the thread was "S & S capo/case hardening." Fred Fred Sturm wrote: > > Mark, > You'll find some discussion in the caut archives > <http://www.ptg.org/archive/caut.php/> around 3/1/99. > Regards, > Fred Sturm > University of New Mexico > > Mark Cramer wrote: > > > > In discussions about string-termination noise, I've heard mention of (re- > > hardening duplex surfaces, but have no idea how this is done. > > > > 1.) cold hardening with a burnisher, or gentle peening with a hammer? > > > > 2.) heating with a torch, arc-welder? > > > > 3.) a combination of the above? > > > > To those who have had success, I welcome your advice. > > > > thanks, > > Mark Cramer, > > Brandon University
This PTG archive page provided courtesy of Moy Piano Service, LLC