> No heat. Thin CA goes plenty deep all by itself. Deeper than > you need, in > fact. The critical area of pin support is right at the > surface of the cap, > and the CA tends to disappear into the depths of the hole > around the pin. > Repeat applications until the stuff stays around the pin at > the surface, > and you'll get the best results. > I can verify this..not that Ron needs verification..I did this procedure to a Bechstein Grand this past summer..wonderful results. I too was skeptical at first..not any more. -Phil Bondi(FL) phil@philbondi.com
This PTG archive page provided courtesy of Moy Piano Service, LLC