Scott, You've probably already thought of this, but how about wall paper remover, TSP, or some photographic H2O2 (28% stuff). Thinking about this, sometimes I have turned the shell upside down and floated a softening solution around wherever the perimeter allowed. Heat lamps might help. Best. Horace Quoting Scott Thile <scott.thile@murraystate.edu>: > No cutting, I need to get it out whole unfortunately! > > Older boards come out pretty easy. Not this one! > > When I was doing this before I built my own boards from scratch, but > can't > do that here :( We used to cut around the perimeter with a router, then > just > pull the remains out and clean the rim up with a chisel. > > Pretty sure Bolduc needs the old board more or less whole to duplicate > it > accurately. > > Thanks, > Scott > > > -----Original Message----- > > From: Richard Brekne [mailto:Richard.Brekne@grieg.uib.no] > > Sent: Wednesday, February 11, 2004 12:00 PM > > To: scott.thile@murraystate.edu; College and University Technicians > > Subject: Re: S&S D Soundboard removal > > > > > > I suppose this means you want to take it out whole, by loosening all > > glue joints ? Or are you planning on cutting part or all of it out ? > > > > RicB > > > > Scott Thile wrote: > > > > >Hello folks, > > > > > >I've got to remove the soundboard from a '60s Steinway D. It's really > in > > >there good. Anyone have any tricks? Need it one piece so I can send it > to > > >Bolduc for duplication. > > > > > >I've removed lots of boards from Steinways from the '40s and earlier, > but > > >the glue used for this one is much tougher! What is it, and what will > > >release it? > > > > > >Thanks, > > >Scott > > > > > > > > > > _______________________________________________ > caut list info: https://www.moypiano.com/resources/#archives >
This PTG archive page provided courtesy of Moy Piano Service, LLC