Yeah, thinned hot hide glue, mostly water to soak into the wood and then bond with the regular strength hide glue when bushing. David ----- Original message ----------------------------------------> From: Mark Cramer <Cramer@BrandonU.CA> To: College and University Technicians <caut@ptg.org> Received: Fri, 04 Jun 2004 13:01:59 -0500 Subject: RE: hot hide glue wash >I wonder if all the super-lubes we're using may come back to haunt us? >We use CLP, McLube etc. on a center-pin as a "release agent"(when re-sizing >a birds-eye w/c.a.) precisely so the GLUE WON'T STICK! Perhaps that's the >problem with the mortises you're dealing with. >BTW, I'm not sure what you're referring to as a "glue-wash" David, (thinned >glue as a "wash-coat?") but if you're looking to purge the wood, TSP >(tri-sodium phosphate) should do just fine. >best regards, >Mark Cramer, >Brandon University >-----Original Message----- >From: caut-bounces@ptg.org [mailto:caut-bounces@ptg.org]On Behalf Of Jim >Busby >Sent: Friday, June 04, 2004 11:15 AM >To: ilvey@sbcglobal.net; College and University Technicians >Subject: RE: hot hide glue wash >David, >I have had that problem. Was it with a Kawai by chance? Tried the glue >wash and it still didn't stick. I finally had to use a different glue. >Jim Busby >-----Original Message----- >From: caut-bounces@ptg.org [mailto:caut-bounces@ptg.org] On Behalf Of >David Ilvedson >Sent: Friday, June 04, 2004 12:27 AM >To: caut@ptg.org >Subject: hot hide glue wash >List, >Do any of you, when rebushing with hot hide glue, have problems with >cloth not holding? Have you tried a thin hide glue wash in the key >mortice prior to bushing? >David I. >_______________________________________________ >caut list info: https://www.moypiano.com/resources/#archives >_______________________________________________ >caut list info: https://www.moypiano.com/resources/#archives >_______________________________________________ >caut list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC