[CAUT] Today's Puzzler.

[Phil Bondi]

Wimblees@aol.com wrote:

> In a message dated 3/17/05 12:42:49 P.M. Central Standard Time, 
> t.seay@mail.utexas.edu writes:
>
>     Damper head hitting the plate strut?
>     If so, move the damper head by adjusting the straight bend in the
>     wire or sand off the edge of the damper head that's striking the
>     strut.
>
>     Tom
>
> You beat me to it, Tom. That's my answer.

well, you're both close. If you know the make-up of a 1915 M&H A Damper 
System, then try again..but you're close.

Remember..I know what the problem is..I'm looking for the remedy.

My back will thank you for it.

-Phil