Wim, I'm surprised that there is a grand pinblock that is not drilled clear through. The pictures pretty much show holes on the underside. Dan Gurnee, HSU, Ret. On Sunday, February 4, 2007, at 09:53 AM, Willem Blees wrote: > Quoting daniel carlton <hacicspe at gmail.com>: > >> hi list >> >> i'm driving tuning pins on a samick grand. i have the PB supported >> with >> the PB support from Schaff, but the bottom lamination is separating >> from the >> PB. i've included pictures. i've got the nuts on the PB support as >> tight as >> they'll go, but the separation still happens. i've made my through >> half the >> pins; i just wanted to see if anyone thinks if i should stop. by the >> way, i >> pulled a small piece of the lamination off, so that's why there's a >> chunk >> missing in one of the photos. >> >> thanks >> >> daniel carlton >> > > Daniel > > I have to agree with Ed, Why are you driving pins in this piano? If > they are not holding, you need to replace the pins. I have had > experience with Samick pins not holding. This is a warrentee problem. > The holes were not drilled right to begin with. (I presume the drill > bit got too dull or too hot when they drilled the block.) If the piano > is still under warrentee, contact Samick. If it is out of warrentee, > repin with 0/4 pins. > > Willem Blees, RPT > Piano Tuner/Technician > School of Music > University of Alabama > Tuscaloosa, AL USA >
This PTG archive page provided courtesy of Moy Piano Service, LLC