That's the plan...heck I should have had it fixed by now... '-] David Ilvedson, RPT Pacifica, CA 94044 ----- Original message ---------------------------------------- From: "Fred Sturm" <fssturm at unm.edu> To: caut at ptg.org Received: 7/30/2009 2:46:57 PM Subject: Re: [CAUT] monkey hanger >On Jul 30, 2009, at 3:23 PM, Jeff Tanner wrote: >> Seriously, I couldn't get the wire to stay in place while I tried to >> heat the solder > Probably because it had got bent out of alignment (the bends not >exactly 90 degree). Adjust the bends as needed, and it will sit there >very nicely. Also, don't heat the solder, heat the metal. Then flow >the solder into the joint (the metal should be hot enough that the >solder will melt on contact and flow). Heat the solder, and it will >bead off and drop on the floor. >Regards, >Fred Sturm >University of New Mexico >fssturm at unm.edu >"I am only interested in music that is better than it can be played." >Schnabel
This PTG archive page provided courtesy of Moy Piano Service, LLC