When you factor in the cost of the knuckles (the most expensive part of a S/F assembly) Is it really worth doing all that rather than just replacing the shanks? David Love www.davidlovepianos.com -----Original Message----- From: caut-bounces at ptg.org [mailto:caut-bounces at ptg.org] On Behalf Of Roger Jolly Sent: Wednesday, November 24, 2010 4:43 AM To: caut at ptg.org Subject: Re: [CAUT] Teflon Bushings Hi Jon, I have done quite a few of these. One drip of CA around the collar works wonders. Regards Roger At 06:23 AM 11/24/2010, you wrote: >I'm reconditioning an action. I want to reinforce the yokes to inhibit >moisture. >Is thin CA sufficient? I also have Epoxy Tech. 301 but would prefer the >ease of CA. > >I'll also be relocating new knuckles from 16 to 17 mm. >-- > >Regards, > >Jon Page > >__________ Information from ESET NOD32 Antivirus, version of virus >signature database 5644 (20101124) __________ > >The message was checked by ESET NOD32 Antivirus. > >http://www.eset.com > >
This PTG archive page provided courtesy of Moy Piano Service, LLC