[CAUT] pinblock material, drilling speed, feed rate ?

[Dr. Henry Nicolaides]

Sharp bit as in new never used.  
Henry

> Date: Sun, 30 Jan 2011 18:18:06 -0500
> To: caut at ptg.org
> From: jonpage at pianocapecod.com
> Subject: Re: [CAUT] pinblock material, drilling speed, feed rate ?
> 
> IUf the bit were loose in the chuck, the chuck would spin but not the bit.
> If the whole thing seized, the motor is underpowered.
> You're using a sharp bit, right?
> -- 
> 
> Regards,
> 
> Jon Page
 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://ptg.org/pipermail/caut.php/attachments/20110130/320fe04b/attachment.htm>