[CAUT] pinblock material, drilling speed, feed rate ?

Jon Page jonpage at pianocapecod.com
Sun Jan 30 18:42:55 MST 2011

Previous message: [CAUT] pinblock material, drilling speed, feed rate ?
Next message: [CAUT] pinblock material, drilling speed, feed rate ?
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

BTW, I drill a Dilignit block about 900 rpm.
-- 

Regards,

Jon Page

Previous message: [CAUT] pinblock material, drilling speed, feed rate ?
Next message: [CAUT] pinblock material, drilling speed, feed rate ?
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

More information about the CAUT mailing list

This PTG archive page provided courtesy of Moy Piano Service, LLC