While I was browsing at a local book store the other week I was leafing through a woodworking magazine. It had an excellent article on the topic of bending wood. I don't recall the name of the magazine, possibly Fine Woodworking? >Dear List, > .... >The piano in question is a Bechstein grand with bent formed cove molding >around the edges of the soundboard. During the process of removing the >plate, this molding shattered ... > >Does anyone have any opinions or suggestions about how to fabricate this >molding and more specifically, how to steam and bend the wood to conform to >the outline of the soundboard? If any of you out there would care to share >any comments you might have about this, I would appreciate it very much and >will pass it on to my colleague. > >Many thanks. > >Tom Seay, RPT > >Tom Seay >t.seay@mail.utexas.edu >The University of Texas at Austin Glenn Grafton Grafton Piano & Organ Co. Souderton PA 215-723-6900
This PTG archive page provided courtesy of Moy Piano Service, LLC