On Mon, 26 Aug 1996 11:09:18 -0500, Avery Todd wrote: >Hi, > For future reference, does anyone know of a source for front rail pins >larger than .174 at the base (the part driven into the key frame)? Pianotek >lists their's at .145 and Schaff doesn't even say what the size is, >although >the ones I have (.174) probably came from there. > I wanted to replace the pins, so I took one out to check the size and the >old pin is .177 in diameter. The new ones I have, at .174, just drop down >into the hole! I think I'm just going to clean them up as best I can and >reuse the old ones. > Since I don't really want to shim all the holes to make them tight, does >anyone have a better idea? Some are pretty rusty and should be replaced. >The one I pulled out, I "had" to shim and replace. > Thanks for any help/ideas. Again! > >Avery > > >_____________________________________ >Avery Todd, RPT >Moores School of Music >University of Houston >Houston, TX 77204-4893 >713-743-3226 >atodd@uh.edu >_____________________________________ > > I don't know how critical the application is but what about getting the existing pins replated? Greg Greg & Mary Ellen Newell gnewell@en.com dt945@cleveland.freenet.edu gnewell@juno.com
This PTG archive page provided courtesy of Moy Piano Service, LLC