>The piano is an old upright, and the family would >like to have it working for their child to practice on. What tool >do I need to inject the liquid into the block? Do I remove the pins >first, or just try to inject it in under pressure of some kind. Allen, If there are no tuning pin bushings, lay the piano on its back with a piano tilter, and apply the solution according to the directions on the brand of solution that you chose. If there are tuning pin bushings, the pin tightening solution has a pretty hard time getting to the area that you are trying to treat. In one instance there was this older studio piano that I treated by drilling a hole through the tuning pin bushings, and then applying the solution after tilting the piano. It was a little slower and more awkward. It did work for the most part, though I still had to replace some tuning pins that just didn't respond. Keith A. McGavern, RPT Oklahoma Chapter 731 Oklahoma Baptist University Shawnee, Oklahoma
This PTG archive page provided courtesy of Moy Piano Service, LLC