Hi Jim, So you are not just a pretty face, smart toooo. It was a great pleasure meeting you at last. Roger At 07:09 PM 26/07/99 -0400, you wrote: > >In a message dated 7/26/1999 7:03:06 PM, John wrote: > ><<Do any of you have a good method that gives uniform backcheck heigth >when reinstalling backchecks on a vertical action using a backcheck >remover/installer chucked up in a drill?>> > >Well "good is in the eye of the beholder" :-) > One method is to cut a block at the height you want the bottom of the >backcheck to be..............cut a slot in in for the backcheck wire to slip >into and when you are installing the new backchecks they will bottom out on >the block and will all be at the same height.........works for grands and >uprights............... >Jim Bryant (FL) > Roger Jolly Baldwin Yamaha Piano Centre Saskatoon and Regina Saskatchewan, Canada. 306-665-0213 Fax 652-0505
This PTG archive page provided courtesy of Moy Piano Service, LLC