Paul S. Larudee wrote: > > Bob, > > Rather than wait to reach you by phone, I thought I'd draft a few > suggestions. From the few things you said I got the impression that you > were reconsidering the original plan to order 100 sets of one size and > 50 sets each of the other two sizes. Oooooooooooooooooooooooooooooooooooooops! That was supposed to go to Pianotek, not Pianotech. Oh, well, it's out of the bag now. For the curious, I'm planning to market a new type of tuning pin which has a narrow gauge from the top to 4mm below the becket and a wider gauge for the remainder, patent pending. The idea is to put the strength and rigidity where it's needed and reduce torque, increase leverage and decrease the need for pin block friction. All will be revealed. Paul S. Larudee, RPT Richmond, CA
This PTG archive page provided courtesy of Moy Piano Service, LLC