What flange to use?

[Roger Jolly]

---------------------- multipart/alternative attachment
At 11:38 AM 02/09/99 -0500, you wrote: 
>
> I have a customer w/ a Lyon & Healy baby grand.  It is need of one hammer
> flange.  I looked through the Schaff catalog but wasn's able to match up the
> part I needed.  Any suggestions on finding one that will work are
> appreciated.  Thanks.


Hi Jeremy,
               If you do quite a bit of grand work, I can highly recommend a
renner sample parts kit.
If the worst comes to the worst, they have some universal flanges that you can
cut a piece off the tail to make fit. At least you will end up with correct
centre pin to flange screw geometry.
Roger
Roger Jolly
Baldwin Yamaha Piano Centre
Saskatoon and Regina
Saskatchewan, Canada.
306-665-0213
Fax 652-0505 
---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/bb/44/01/72/attachment.htm

---------------------- multipart/alternative attachment--