Thanks for the fine informational posting Bill. This one is a keeper ! BSimon999@AOL.COM wrote: > Greg Newell wrote; > > <<problems incurred when drilling a pin block are from the heat > generated...pre drill?... dangers be in this plan?>> and <<favorite > source or type for the drill bits needed?...type of bit I would use? Are > there bit coatings I should use? Are better bits manufactured using > coatings?...>> > > I HAVE to respond because drill bits and drill bit sharpeners are a kind of > hobby for me. Drill bit technology has improved greatly in the past several > years, and there are now many inproved tip designs, shank designs, new > materials, and coatings, The best bits today put the old jobber bits to > shame..... snippity snip... > > We have to use better technology just to do as well. > > Good luck. > > Bill Simon > Phoenix -- Richard Brekne Associate PTG, N.P.T.F. Bergen, Norway
This PTG archive page provided courtesy of Moy Piano Service, LLC