I have not been real successful with this method. Maybe runout on my Crapsman. Thanks for the note. Newton Norman Barrett wrote: > > Hi Newton, > > Are you familiar with the trick of clamping a scrap board on the drill press > table, drilling a hole the diamater of the dowel in this scrap board, then > drilling the dowel by pushing it up through the hole? that works pretty > good. > > Norm Barrett > > Newton Hunt wrote: > > > > > > > I could even send a drawing of the jig that I use on my drill press and > > > on the bandsaw and would be glad to do so if that is what you want. > > snip > > > > > > I am rarely successful in drilling a hole consistently in > > the center of a dowel so I would love to see you jig for > > doing so. > > > > Oh, by the way, I do know everything, but it keeps falling > > out of my basket and gets lost. > > > > Newton
This PTG archive page provided courtesy of Moy Piano Service, LLC