> 1) Do you route > out large sections of the pin block and then fill those sections with a > large piece of pinblock, cut to the right size? If so, how large are the > sections (how many pins are in each section)? Yes. Route out as much material as is needed to cover the pinned area and replace it with new material cut to fit and bedded in place with a good glue like epoxy since it tends to fill gaps better than yellow glue does. That is if you can get that perfect fit. I know I cannot! I have seen this done on a Bechstein as well as an upright. Seems to work well for everyone. Hope this is helpful. Newton
This PTG archive page provided courtesy of Moy Piano Service, LLC