---------------------- multipart/alternative attachment Hire a technician. This is not a self-help forum. Jon Page At 09:01 AM 08/23/2001 -0700, you wrote: >My Ricca & Son has monochords from A1-F#10, bichords >from G11-B27, and triple-string plain notes (trichords >-- not sure if you use it universally or only for >wound trichords) from C28-C88. The break is at >B27/C28 and all trichords are plain wire. Currently >all my trichord dampers are flat felt and all my >bichord and monochord are wedges. I was wondering -- >up to approximately how far would you recommend >putting trichord wedge dampers in? I have no plans to >rescale my piano (as in replace trichord plain notes >with bichord wound notes). I currently have a set of >50 flat felt dampers (way more than enough) so I can >replace those, but I don't yet have the wedges. What >do you think the approximate cost of the wedges would >be? > >--- Jon Page <jon.page@verizon.net> wrote: > > At 10:13 PM 08/22/2001 -0400, you wrote: > > >Since I'm replacing the damper felts on this piano, > > I'm torn as to whether I > > >should duplicate this setup or go with matching > > damper felts. > > > > > >Any thoughts? > > > > > >Tom Sivak > > > > Match the felts, don't repeat someone else's lame > > idea/mistake. > > > > Get them travelling straight and don't forget to > > rebush the guide rails. > > > > Regards, > > Jon Page, piano technician > > Harwich Port, Cape Cod, Mass. > > mailto:jon.page@verizon.net > > http://www.stanwoodpiano.com > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > >__________________________________________________ >Do You Yahoo!? >Make international calls for as low as $.04/minute with Yahoo! Messenger >http://phonecard.yahoo.com/ ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/bd/a8/45/4e/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC