Hi Terry, Yamaha recommends the back installation for the Diskclavier series of uprights. I would not put even a partial system inside the case of such an instrument. At 10:23 AM 12/30/2001 -0800, you wrote: >Customer has a Yamaha U1 with the "silent" feature. The MIDI (open face) >circuit board is in the area where a dehumidifier would normally intersect >it, so i'm wondering if it would be safe to install the rod LOWER than >usual, which in this case would be about 6" from the bottom. This position >would keep the rod (50 watts) about 4-6" below the circuit board, but would >this be ok? There would be no HUmidifier installed, only the DEhumidifier >and stat. I figure since the customer's in the Beach area, where the average >humidity is 60-100% year round, this would keep excess moisture from >condensing on the open circuit, in addition to retarding corrosion. Btw, a >rear mounted DC system is not an option. Thanks in advance for tips & >advice! happy twothousandtwo! > > >Terry > >_________________________________________________________________ >Join the world’s largest e-mail service with MSN Hotmail. >http://www.hotmail.com > > > Regards, Don Rose, B.Mus., A.M.U.S., A.MUS., R.M.T., R.P.T. mailto:drpt@sk.sympatico.ca http://us.geocities.com/drpt1948/ 3004 Grant Rd. REGINA, SK S4S 5G7 306-352-3620 or 1-888-29t-uner
This PTG archive page provided courtesy of Moy Piano Service, LLC