--- Farrell <mfarrel2@tampabay.rr.com> wrote: > OH, Joe, please be more specific! > > > As for the "Stretch" factors, that others are > advocating, YIKES! They must > > like replacing strings. Some of those > "over-shoots" are far in excess of > the > > normal sting breakage tolerances. > > I never overshoot more than 25 cents (I usually keep > it well below that). > What kind of "over-shoots" are you referring to? > It's obvious to me 25 cents > max is typically within string breakage tolerances > (on a string in good > condition). But I wonder about string deformation. > How much can one pull it > up above pitch without doing something weird to it - > deforming it in some > way. Anyone have any kind of data on that - I > realize it will vary with > different string diameters, but maybe at least > general info??? > I've broken about 5 strings so far in my Ricca, one in the temperament while I was playing the piano and four in the bass while I was tuning. All broken strings snapped when they were at or below pitch. Do you guys think there's a way to avoid breaking strings in the future without replacing them? Although the strings are 88 years old, I don't have the money to do a full restringing job. (I've already replaced the lowest 2 bass strings and that took a good sized chunk out of my wallet.) I WOULD like to be able to keep the piano tuned at 440. (It was a half-step flat a year ago when I got it and when I pulled it up I didn't break any strings; the strings broke during subsequent maintenance tunings.) > Terry Farrell > > ----- Original Message ----- > From: "Joseph Garrett" <joegarrett@earthlink.net> > To: <pianotech@ptg.org> > Sent: Tuesday, November 06, 2001 1:26 PM > Subject: Pitch Raising > > > > Bill Bremmer & List, > > I've been following this "thread". Yes, Bill, if > you use the pitch raising > > program, as I outlined in the PTJ, Dec.1999, it is > very possible to get > > "Dead on", with just two passes on a 100cent pitch > raise. If it doesn't > > happen, then I would be looking very carefully at > the overall structure of > > the "victim piano". If the piano is solid, there > should be no problem of > > attaining pitch in two passes. > > As for the "Stretch" factors, that others are > advocating, YIKES! They must > > like replacing strings. Some of those > "over-shoots" are far in excess of > the > > normal sting breakage tolerances. My advice is: > DON'T DO THAT! > > Regards, > > Joe Garrett, RPT, (Oregon) > > > __________________________________________________ Do You Yahoo!? Find a job, post your resume. http://careers.yahoo.com
This PTG archive page provided courtesy of Moy Piano Service, LLC