Joe, Sorry, mayber it's the language thing, but I don't know what "swedge" means. Could you please explain how this is done for a native french Canadian. Thanks Marcel Subject: Re: replacing upright liftrod hanger Clyde, Cut the piece of rod that you will use longer than you will need. Too long is much better! Do not bend but swedge the end that will go into the lift rod so that it will wedge in solidly. Drive it in place and next bend the hanger and cut off the excess from both ends if there is any. Joe Goss imatunr@srvinet.com www.mothergoosetools.com
This PTG archive page provided courtesy of Moy Piano Service, LLC