> Everett, studio.....buzzing bridge pins on several notes in mid >section....Question------Will CA glue cure this problem...if so how do I >apply...loosen string -move pin over??No..Yes?? Epoxy Glue???Elmer's Yellow >Glue?? > Most of time I use Elmer's..after I loosen string, dobb in Elmer's, >re-insert pin, sometimes drive a little deeper, sometimes place string on >opposite side and tighten a bit until glue sets......Is there a better, >quicker way? -----CA Glue????? >Tommy Black >Decatur, Ala. Tommy, Definitely CA, but a question. A buzz? I don't recall ever hearing a bridge pin buzz from being loose. False beats, yes, but no buzzes. Is there positive front bearing, and is there sufficient string stagger angle across the bridge where the buzz is? Also check clearance of the speaking length from the side of the next notch over. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC