This is a multipart message in MIME format ---------------------- multipart/alternative attachment I've used a slightly damp rag followed immediately with a dry one= and have never noticed a problem with pianos I've followed for= years. I agree that saturating the ivories would be a mistake. = I don't really know how quickly moisture goes into ivory= though...I would think the elbow grease would be loosening up= more ivories than a little moisture... David I. ----- Original message ----------------------------------------> From: David Love <davidlovepianos@earthlink.net> To: <pianotech@ptg.org> Received: Tue, 13 Aug 2002 12:37:19 -0700 Subject: Re: Cleaning keys again I'm sure that you are careful, but I try to avoid moisture around= ivories at all. I think the effects of loosening the glue joint= are cumulative. Best way to clean them (another topic) is just= to rub them out. Takes a bit of elbow grease, but over time= it's a safer way to go. David Love ----- Original Message ----- From: Baldwin Yamaha Piano Centre To: pianotech@ptg.org Sent: August 13, 2002 12:01 PM Subject: Re: Cleaning keys again David: It's a wipe it on wipe it off type of operation, we have= never had a problem with ant of the glue joints. Roger At 10:43 AM 8/13/02 -0700, you wrote: Roger: I think that's okay on keys with plastic tops but I= wouldn't use it with ivory. I just prefer to keep all moisture= away from water soluble glue joints. David Love ----- Original Message ----- From: jolly roger To: pianotech@ptg.org Sent: August 13, 2002 8:39 AM Subject: Re: Cleaning keys again Hi David, I used to use a scraper, as that was the method= taught. Now I use the Fantastic for the sides, it just cuts= through that black crud, and finger grease. No material is= removed, and it works well getting the dirt from under the key= lip, so the fronts also look clean. One cleaner to do the tops,= sides and fronts. Rubber gloves are recommended, as it is hard on the skin. Regards Roger At 08:03 AM 8/13/02 -0700, you wrote: I think a disc sander is a bit dangerous. It's too easy to= reduce the width of the key. Just scrape them with a small= scraper or a razor blade. David Love ----- Original Message ----- From: Wimblees@AOL.COM To: pianotech@ptg.org Sent: August 13, 2002 7:12 AM Subject: Re: Cleaning keys again In a message dated 8/13/02 4:05:29 AM Central Daylight Time,= collin.s@skynet.be writes: Hi List. Thanks to all for the useful great input. So may I ask again what about cleaning the dirty wood of the keys= (not the keytops, this has just been fully discussed) ? Best regards St=E9phane Collin. I sand them with a disc sander. Wim Roger ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/24/57/65/53/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC