In a message dated Thu, 29 Aug 2002 11:07:55 AM Eastern Standard Time, lclgcnp@yahoo.com writes: > > > If you wanted a quick way to seal drilled - > all-the-way-through pinblocks from moisture infusion, > I would recommend taping the underside with aluminum > duct tape, covering the whole exposed expanse. 100% > waterproof, and probably never fall off, as this stuff > is practically impossible to remove once stuck. I put > it on upright pinblocks, under the lid, as humidity > changes seems to loosen the pins right above the bass > break where they are closest to the pinblock top. > Might aid tuning stability, too. > Gordon Stelter Good stuff Gorden, I used to work for an airlines and we called it 600 mph tape because you could tape down a flaw on the outside of a plane and it would not come off, even at 600 mph. David Koelzer Vintage Pianos DFW
This PTG archive page provided courtesy of Moy Piano Service, LLC