Sounds like you want to get Nick Gravagne's computer action program. It will do exactly what you want. He has an ad in the Journal. Terry Farrell ----- Original Message ----- From: "Richard Moody" <remoody@midstatesd.net> To: "Pianotech" <pianotech@ptg.org> Sent: Tuesday, December 10, 2002 8:52 PM Subject: 10mm = 1 3/4 inch blow > > > I referred to > > in that note [Baldwin SD-10] actually had a pretty good action > ratio. A 10 mm > > dip would produce a blow of only 1-3/4". > > > We do service a 40's Baldwin L that regulates to 9.5 mm x > 1-7/8". > > Bob > > > > If you wanted a 1-7/8 blow from the 10 mm dip, how far would have > to move the capstan and which way I assume towards the back check. > What I am getting at is there a chart what will show for every mm > the capstan is moved the hammer will go up x mm ? Does anyone > have a formula I can plug into my spread sheet? ---rm > > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC