The referenced web site indicates that a rough surface or a finish will goof up the reading on the pin-less meter. ----- Original Message ----- From: "Don" <drpt@sk.sympatico.ca> To: <pianotech@ptg.org> Sent: Thursday, January 24, 2002 10:41 PM Subject: Re: moisture meters > Hi, > > Does anyone know if they will work thru a finished soundboard? > > > At 10:07 PM 1/24/02 -0500, you wrote: > >. > > > > > > > > IMHO Moisture meters are not necessary for drying spruce.Not only > >that but some moisture meters say they will measure down to say 4% mc but > >they come with a conversion chart that changes the rerd numbers to > >something too high which then becomes irrelavant, meaning it doesn't really > >have the capacity to read spruce at 5 or 6% emc. > > Dale Erwin > > > > > > Came across an interesting site (below). Can get pinless meters for $100 to > > $200. The model CT100 is $198 (I think that is in US dollars). > > > > http://www.electrophysics.on.ca/ > > > >& Species > > The immensely popular CT100 was the first digital "no pins" moisture meter > > introduced to the woodworking market, in September 1993. One-inch depth > > sensing, with electronic species compensation--just turn the density control > > to the setting for your material and the large LCD display instantly shows > > the corrected moisture content! Rugged and reliable for industry, yet > > affordable for the hobbyist. Low battery warning symbol in display. > > Incredible slimline pocket size only 4.7 x 2.7 x 1.0 inches. > > > > I looked at some other meters from scientific supply houses and many of them > > have a low-end moisture content of 6% - that's just getting into our range > > of interest! > > > > Let us know if you find any other really great meters! > > > > Terry Farrell > > > > ----- Original Message ----- > ><> > ><><> > > Sent: Thursday, January 24, 2002 1:08 AM > > Subject: moisture meters > > > > > >> Greetings once again, > >> I am spending much time of late thinking through the soundboard > >> making and installing process. It seems to me that even though the Sitka > >> I have purchased and may one day actually receive has been kiln dried. I > >> do not know what it's moisture content will be and how whatever level it > >> is presently at will affect my efforts. It occurs to me that I might > >> want to obtain a moisture meter to test the wood throughout the process. > >> Are there any recommendations as to either the need and or the model or > >> style meter one should buy? I'm looking for the most bang for my buck. > >> (aren't we all) I hope to use it for many other woodworking items as > >> well. Do any of you have opinions on how well the needle-less ones work > >> vs. the traditional needle type? Any light you could share would be > >> helpful. > >> > >> Greg > >> -- > >> Greg Newell > >> mailto:gnewell@ameritech.net > >> > > > > > > > > Regards, > Don Rose, B.Mus., A.M.U.S., A.MUS., R.M.T., R.P.T. > > mailto:drpt@sk.sympatico.ca > http://us.geocities.com/drpt1948/ > > 3004 Grant Rd. > REGINA, SK > S4S 5G7 > 306-352-3620 or 1-888-29t-uner
This PTG archive page provided courtesy of Moy Piano Service, LLC