Adjusting dampers to tray

[Greg Newell]

Matt,
         Punchings will be necessary for this one as far as I know. One way 
to minimize the need for extravagant amounts of punchings is to make sure 
those wire are nice and clean and free of screw depressions before you put 
them back in. Hope this helps.

Greg Newell


At 06:04 PM 6/7/2002, you wrote:
>Greeting esteemed colleagues:
>
>I will be reassembling a damper system in an old S&S grand.  It is one of 
>those systems that was born without regulating screws on each underlever 
>for adjustment to the lift tray.  Is there any efficient way to adjust 
>them so that they all lift in unison with the pedal?  I'm aware of the old 
>method using center rail punchings, or something similar, as shims, but 
>there must be a better way.  Any advice would be appreciated.
>
>Thanks,
>
>-Matt Wynne

Greg Newell
mailto:gnewell@ameritech.net