Newton, what diameter of tubing, ID or OD are you suggesting, how long of a piece of tubing, and in the question mark loop what diameter is the loop?. Just trying to picture this. Thanks, Gordon Holley, Goshen, IN On 10 Jun 2002 at 11:04, Newton Hunt wrote: > Take a piece of brass or copper tubing and bend it into a question mark (?). > You will need some way (piano wire) to prevent the tubing from collapsing. > THread the tubing under the pressure bar, stick the wire into the hole then lift > the wire and tubing out. Neat, effective and easy. > > Newton
This PTG archive page provided courtesy of Moy Piano Service, LLC