>...Replacing every other one seems like a good system. Somebody else >mentioned this... > >Tom Sivak Tom, List, You can also do preliminary bending of the damper wires on a workbench. You should find the bass dampers all have the same bends. Pretty generic and a much easier thing to do out in the open. You will also find similar patterns in the tenor and treble areas, at least enough so as to make preforming the wires a significant timing saving act. All the detail adjusting can take place when they are actually installed in the action. Good Luck, Keith McGavern Registered Piano Technician Oklahoma Chapter 731 Piano Technicians Guild USA http://www.highpointpiano.com/ptg/conv/chicago2002/
This PTG archive page provided courtesy of Moy Piano Service, LLC