This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment In this case I think I'd look into dropping the tail of the plate just a = bit. I would like to see a bit of string bearing down there. Be sure you = don't overload the bass bridge, though. Del ----- Original Message -----=20 From: David Love=20 To: Pianotech=20 Sent: June 16, 2002 12:04 PM Subject: Single Strings and bearing I'm adding some single strings (6) to the lower part of the tenor = section of a piano to smooth out the scaling. The bearing is minimal at = the bottom of the tenor bridge and the singles with their wrap actually = put those strings slightly negative. Would you be concerned about those = singles and therefore opt to compromise the scaling and omit them = keeping a no singles pattern? Or will they likely not be a problem = since they won't change the overall pressure on the bridge that much. =20 David Love ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/c1/70/ed/1d/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC