Phil I just have to nominate Susan for a prize here as well... for post arbustus arguo of the first class :) Grin...I wonder how many Latin freaks there are out there. Susan I might recommend selecting the Turtle Dove felt by Guccini. It has a slight belus lente character I think you will find appealing... comes in dark regal green and ivory. RicB Susan Kline wrote: >Oops, I sent off my answer before noticing that you already >had two winners -- however ............... > >Seems to me that you didn't have a weak rep spring; you had a >seizing center pin in the rep lever. The fallboard may say "Wurlitzer", >but you have identified it as a Samick. They are prone to failing >center pin plating. I've taken a couple of photos of a (vintage) Samick >wippen lying on a table with the jack sticking its tongue out >through the totally seized rep lever. > >"This piano has a history of tight jacks" corroborates. Usually, >of course, the hammers fail first. They start by working pretty >well when cold, but seize up as the friction of playing warms them. >At first they seem just a little slow to return, and then they >stop repeating well, and finally, they hang in air. > >If one rep lever is seizing, can a few more be far behind? And >you may find that a few dampers start mysteriously hanging >up. No point in over-easing the damper guide rail bushing at >that point, if it's a seized underlever flange. > >If this seems like a logical scenario, take out the most offending >part, remove the center pin, and examine it under magnification. >If the nickel plating is failing, you'll see it is scored through to >the brass on the contact areas. > >If this is the case, your customer is right. It's definitely a >warranty issue, and like a bad penny, it comes back over and over >and over again. > >Oh, have FUN!!!! > >Susan > Richard Brekne RPT NPTF Griegakadamiet UiB
This PTG archive page provided courtesy of Moy Piano Service, LLC