There are available small hole saws screw removing bits of several sizes. Mine aren't very long, about 1 3/4 inches. They should do it. Carl Meyer Ptg assoc Santa Clara, Ca. ----- Original Message ----- From: "Farrell" <mfarrel2@tampabay.rr.com> To: <pianotech@ptg.org> Sent: Wednesday, June 18, 2003 5:50 AM Subject: Broken Screw Extraction > Anyone have any good suggestions on how to remove a broken screw from a pinblock? One of the pressure bar screws on the upright I am restringing twisted off. The break is slightly above the pinblock surface, but well below the plate (about a half-inch hole in the plate). I think it is about a #10 screw. > > Just when things were going fairly well........ > > Terry Farrell > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC