In a message dated 20/06/03 2:03:40 PM, RNossaman@cox.net writes: << Typically, I can get a new screw in Delignit in one shot without any pre-threading just by sizing the pilot appropriately and a little wax for lubrication. >> I agree. I could do the whole thingee in one shot but I find that the 'pre-threading makes for less screw head deformation on the new screws and fewer screwdriver slips @6&&*^$#@!!!!!! when installing the new screws in the regilded plate. :-) Jim Bryant (FL)
This PTG archive page provided courtesy of Moy Piano Service, LLC