Terry, How recently did that "Bozo" repin the piano? Is s/he anywhere nearby? You might suggest that the customer call that person for piano tuning. If technicians, or movers/shakers of piano manufacturers, who pin the pianos so tightly were required to put a couple tunings on them, we might actually get somewhere, especially if *they* need a couple days or weeks to recuperate afterwards. Regards, Clyde Farrell wrote: > A first for me yesterday. > > I went to service an old Knabe upright (rewhatevered a few years ago). Lady said it needed tuning and a note fixed. Piano was 50 cents flat. I started raising pitch, and after turning six tuning pins I went outside to get my torque wrench. I tested the six that I had already moved and about a half-dozen more and all but one were WAY over 200 inch-pounds torque. I would guess most were between 250 and 300 inch-pounds. My torque wrench looked like it was ready to become a pretzel without even moving most of them. As I had injured (pulled something in my neck) myself a month ago on a new Boston studio followed by a nasty 1098, I was not ready to miss another couple weeks of work to finish this one tuning. I told the lady that I would not tune her piano and why. She was quite understanding. > > I would sure like to know what Bozo put those new tuning pins into that piano. S/he obviously does not attend PTG conventions and/or participate on this wonderful list! > > My arm was a bit sore this morning. I am very glad I did what I did. At the time I was really wondering if I was just being a wimp - but clearly, such was not the case.
This PTG archive page provided courtesy of Moy Piano Service, LLC