----- Original Message ----- From: "J Patrick Draine" <draine@comcast.net> To: "Pianotech" <pianotech@ptg.org> Sent: Tuesday, September 30, 2003 12:29 PM Subject: Robertson fastener bits > Dear List, > What's the best source for Robertson bits that will fit plate screws > (for a miserable "Grand" spinet if you must know)? It looks to be about > half a centimeter square. > Thanks, > Patrick Draine > Billerica, MA > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives > > Is a Robertson bit a square drive bit? If so, maybe there's some steel square bar stock that will fit. Just bend a 90 degree elbow into it, like an Allen (hex) wrench. Or a woodworking store might have square drivers. Maybe even Sears? Or take an old screwdriver or other useless or broken tool that has a shank large enough and file a square end on it. --Dave Nereson, RPT
This PTG archive page provided courtesy of Moy Piano Service, LLC