-----Original Message----- From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org]On Behalf Of Joey Recker Sent: Monday, October 13, 2003 6:16 PM To: 'Pianotech' Subject: Brass Rail Tension How do I check the tension for center pins in a brass rail? I Any suggestions? Joey Recker Invert the hammer/butt assembly. Push the center pin through the bushed holes, grab the center pin in the middle or on the excess end with a needle nose pliers tight enough to keep the pin from turning, swing the hammer. 2-3 cycles will do it (a cycle is 1 swing forward and 1 swing back). Paul C
This PTG archive page provided courtesy of Moy Piano Service, LLC