---------------------- multipart/alternative attachment >At 5:37 AM -0800 27/10/03, David Love wrote: > > >I'm about to invest in a bunch of soundboard clamps. Any suggestions about >type, make, especially with cost considerations would be appreciated. > >David Love >davidlovepianos@earthlink.net > Hi David, Good to see that you're taking the plunge. We made our own clamps, but it took a few days to make the set. A diagram of our design (which was dimensioned so as to be useable on grands from the smallest to the largest rimmed concert grand) can be found at; http://overspianos.com.au/clamp.jpeg The spine of our clamps were made from light gauge RHS. You can see the clamps in use at; http://overspianos.com.au/3glrs.html We made 35 in total, with five of them being deeper to accommodate the rear leg support block. Ron O. -- OVERS PIANOS - SYDNEY Grand Piano Manufacturers _______________________ Web http://overspianos.com.au mailto:info@overspianos.com.au _______________________ ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/b0/08/8d/09/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC