Well if you DID read the paragraph below, you would plainly see that the action, while old, is certainly not "worn out". And as for my saying that "any hammer" would be an improvement; that's obviously a fact, but I am NOT "desireing to put on the least expensive set of hammers". Unless you consider Abels to be "cheapies". Basically, this piano action will be in very decent shape with new hammers, dampers and bridals; not exactly a "Total overhaul", which is not at all necessary. Terry Peterson ----Original Message Follows---- From: Richard Brekne <Richard.Brekne@grieg.uib.no> Reply-To: Pianotech <pianotech@ptg.org> To: Pianotech <pianotech@ptg.org> Subject: Re: Imadegawa hammers Date: Thu, 12 Feb 2004 09:26:09 +0100 pianolover 88 wrote: ><Sounds to me like you would be just as well served by glueing leather >strip covering on the existing hammers. Cheers >RicB> > > >I've been accused of being gulable, but you've GOT to be joking! Actually, no. You have described what has sounded like a near total wreck, that you are desireing to put on the least expensive set of hammers... you describe your customer as not exactly the most critical player.. you even said at the outset... "So, I'm sure ANY new hammers will be a big improvement,..." You havent really mentioned whatelse you are going to do... and after several posts it just sort of sounded more like this was going to be less then a full boat job. I got the impression that the action was beat to heck to tell you the truth. So... in the end... I decided to express how all this was beggining to sounding in the end. If this doesnt represent a good picture of what you are doing, dealing with.... well then its been way to easy to get that idea. The paragraph below paints quite a different picture then the one I've been getting up to now. All that said... I've seen some pretty nice work done with leather strip recoverings. Like anything else you can opt for a thing, and do it poorly or do it professionally. Not my kind of solution... but I wouldnt simply discount the proceedure out of hand. Cheers, and good luck with your project. RicB > >First off, I'm HAPPY to do the work, and I am getting paid VERY well for >it. Having said that, the piano in question is worth the repair TO THE >CUSTOMER! It's been in her family through generations, almost since it was >new (1896!). The case is in beautiful shape, as are the keys. The action is >not "Shot", but it does need hammers, bridals and dampers, in addition to >the usual regualtion. All the action centers are fine and need NO >re-pinning. The other felts and various parts,like punchings were replaced >sometimeago, but are fine. Again, this is part of what technicians do, and >I enjoy the hell out of it! > >Terry Peterson > _______________________________________________ pianotech list info: https://www.moypiano.com/resources/#archives _________________________________________________________________ Find great local high-speed Internet access value at the MSN High-Speed Marketplace. http://click.atdmt.com/AVE/go/onm00200360ave/direct/01/
This PTG archive page provided courtesy of Moy Piano Service, LLC