Correction: in my description picture 2 and 3 are reversed. Sorry. Carl ----- Original Message ----- From: "Carl Meyer" <cmpiano@comcast.net> To: <pianotech@ptg.org> Sent: Sunday, February 22, 2004 12:50 PM Subject: Sohmer > I recall that I did some extensive work to a 7'2" Sohmer a couple or three > years ago. It was a piano teacher that was a good friend of my daughter. > The action was a disaster. Hammers blocking strings, new key tops rubbing > each other etc. Her regular tuner (An RPT from our chapter that I've never > seen at a meeting or convention) told her the piano wasn't worth rebuilding. > > I only worked on the action and now even the professor of Piano at Santa > Clara U. is impressed with it. > > I went to see it yesterday to take pictures. > > Betty's piano 1 shows a felt behind the agraffe on the bridge installed > before I saw it. I left well enough alone. The agraffes go up to the top. > You might notice that the rod behind the felt has sunk into the bridge on > one side more than the other. Picture 2 shows this in greater detail. > > Picture 3 shows that in the top section it differs only in that the rod is > smaller. Tilting of the rod is greater but doesn't show up well in the low > resolution shot. > > That was the first piano with bridge agraffes I'd seen. > > Yesterday I measured the speaking length of note 88. Would you believe 62 > mm? Wow. I'm sure this piano has been restrung. I'm getting curious > enough to go back one of these days and measure the complete scale. It's a > great sounding piano, sound board cracks and all, and the strings haven't > broken yet. Amazing. > > More to come > > Carl Meyer Ptg assoc > Santa Clara, Ca. > ---------------------------------------------------------------------------- ---- > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives >
This PTG archive page provided courtesy of Moy Piano Service, LLC