Hi Mark, After using the plastic ones with good results, and seeing a demonstration of the brass cauls, it would be the brass cauls for me. The cost and not doing that much bushing work keeps me from what I consider a better way. BTW if you do go whole hog, get the Bush Master as well. Cuts down on the time it takes to dot he job. Joe Goss RPT Mother Goose Tools imatunr@srvinet.com www.mothergoosetools.com ----- Original Message ----- From: "Mark Davidson" <mark.davidson@mindspring.com> To: <pianotech@ptg.org> Sent: Friday, November 12, 2004 12:51 PM Subject: making key bushing cauls > Various cauls available for sale, but I was considering making these using either router or table saw and some appropriate machinable plastic. Wondered if anyone had any tips (besides the obvious - "buy them"). > > -Mark > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC