Pinblock drill picture.

[Bob Hull]

Richard, 
I can see the drill but cannot really make heads or
tails about the set-up.  The picture seems like it is
too close-up.  Do you have a shot from further away?

Bob Hull

--- Richard Oliver Snelson <rsnelson0984@mchsi.com>
wrote:

> Re: A-440, ethics AND the bodI promised a while back
> to send pictures of my converted Jet mortising drill
> 
> system for drilling pinblocks. The plate it's
> sitting on pivots and can be 
> adjusted to change the drilling angle. I use a 35lbs
> lead weight on the back 
> when in use. Let me know is you can't see this and
> I'll send it directly to 
> you.
> 
> Richard Snelson 
> 



		
__________________________________ 
Do you Yahoo!? 
Check out the new Yahoo! Front Page. 
www.yahoo.com