I'll take a couple more with a different camera and send them directly to you. Jeannie wants them for the journal also. The mount is a little more complex than the picture show as the drill post has been inverted and sits on a piviot post attached to the base. I want to also tell the source of the drill chuck extension which comes from Garrett Wade. Rich Richard Oliver Snelson ----- Original Message ----- From: "Bob Hull" <hullfam5@yahoo.com> To: "Pianotech" <pianotech@ptg.org> Sent: Sunday, November 14, 2004 10:55 PM Subject: Re: Pinblock drill picture. > Richard, > I can see the drill but cannot really make heads or > tails about the set-up. The picture seems like it is > too close-up. Do you have a shot from further away? > > Bob Hull > > --- Richard Oliver Snelson <rsnelson0984@mchsi.com> > wrote: > >> Re: A-440, ethics AND the bodI promised a while back >> to send pictures of my converted Jet mortising drill >> >> system for drilling pinblocks. The plate it's >> sitting on pivots and can be >> adjusted to change the drilling angle. I use a 35lbs >> lead weight on the back >> when in use. Let me know is you can't see this and >> I'll send it directly to >> you. >> >> Richard Snelson >> > > > > > __________________________________ > Do you Yahoo!? > Check out the new Yahoo! Front Page. > www.yahoo.com > > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives >
This PTG archive page provided courtesy of Moy Piano Service, LLC