This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment Hi Richard, Very carefully, <G> It is really quite easy with a micro fine needle inject into the top of = the bushing/tuning pin. By top I mean skyward. Let the needle go into = the hole if it will. Gently inject slowly. You want to let the CA go in = as far as it can. This is different than doing the whole piano or = section as you need to think of it as a one step process more than what = I have indicated before. Tune or move the pin to judge the results and = then you can try to add more CA. Joe Goss RPT Mother Goose Tools imatunr@srvinet.com www.mothergoosetools.com ----- Original Message -----=20 From: lgulli2586=20 To: Pianotech=20 Sent: Tuesday, November 16, 2004 8:02 PM Subject: CA in a hurry=20 Hi list How do you go about getting CA glue into an upright pin block, as in = just a few. Outside of lugging in a tilter to someones house. Thanks in advance Richard G. ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/9c/0b/14/67/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC